X-COLOR 3D Shades System


Apply Vita 3D shades system

Special:TO Incisal Liquid

Coloring Liquid:

0M1 0M2 0M3

1M1 1M2

2M1 2M2 2M3 2L1.5 2L2.5 2R1.5 2R2.5

3M1 3M2 3M3 3L1.5 3L2.5 3R1.5 3R2.5

4M1 4M2 4M3 4L1.5 4L2.5 4R1.5 4R2.5

5M1 5M2 5M3

X-COLOR 3D Shades System

Dyeing methods: 

Before dyeing , clean the zirconia teeth should be cleaned with a brush and blown up with an air gun(or clean with clean water or ultrasonic wave, dyeing must be done after drying )。

Coping dyeing


1、Choose proper container at demands and pour in coloring liquid;

     Note: shake the coloring liquid evenly;
2、Put the zirconia teeth into coloring liquid with a plastic tweezer ,dipping for 2 mins;
  Note: Make sure the whole teeth in the coloring liquid , do not separately dip different part of the teeth;
3、After dipping ,take the teeth out with a tweezer and clean the liquid on it with tissue(do not put the teeth on water-absorbing objects for a very long time;
  Note:Container, tweezer,tissue and other tools should be cleaned before operation;
4、Dry the zirconia teeth with a constant temperature box(100° for 20mins)or infrared light (30mins in a distance of 10cm)
  Note:Drying time for coping could be lessened propriately,while the dying time for crown ,bridge and bridge with missing teethcould be increased correspondingly.

Crown dyeing

Incisal brushing+ dipping:

1、Brush the incisal part(or cusp, edge ) of zirconia teeth two times evenly with incisal liquid using an op pen ;
   Note:When brushing the incisal part, pls avoid imbuing to other parts;
2、Dipping(same as the copping dyeing and dipping)


Storage temprature:0~10°;

Pls pay attention to the labels to avoid mixing up and failure in dying ;
This coloring liquid are specialized for XTCERA zirconia blanks, do not utilize for other blanks or mix with other coloring liquid;
Pls operate as recommended to get the best dyeing result.

Copyright ©2012 - 2018 XTCERA
8600TEL: 86 0755-8600 1804
FAX: 86 0755-8600 1486